Fix missing @clicksequence problem with older Texinfo versions.

[pspp-builds.git] / doc / utilities.texi

diff --git a/doc/utilities.texi b/doc/utilities.texi
index 35ea20e2131d42cb4e660db4d29973a2a7408cea..6882aa2165f525aa2b12ae466da5d762eabe95af 100644 (file)
--- a/doc/utilities.texi
+++ b/doc/utilities.texi
@@ -374,8 +374,10 @@ SET
         /COMPRESSION=@{ON,OFF@}
         /SCOMPRESSION=@{ON,OFF@}
 
-(security)
+(miscellaneous)
         /SAFER=ON
+        /LOCALE='string'
+
 
 (obsolete settings accepted for compatibility, but ignored)
         /BOXSTRING=@{'xxx','xxxxxxxxxxx'@}
@@ -414,10 +416,13 @@ default.  Any real value may be assigned.
 
 @item DECIMAL
 @anchor{SET DECIMAL}
-The default DOT setting causes the decimal point character to be
-@samp{.} and the grouping character to be @samp{,}.  A setting of COMMA
+This value may be set to DOT or COMMA.
+Setting it to DOT causes the decimal point character to be
+@samp{.} and the grouping character to be @samp{,}.
+Setting it to COMMA
 causes the decimal point character to be @samp{,} and the grouping
 character to be @samp{.}.
+The default value is determined from the system locale.
 
 @item FORMAT
 Allows the default numeric input/output format to be specified.  The
@@ -698,6 +703,37 @@ Be aware that this setting does not guarantee safety (commands can still
 overwrite files, for instance) but it is an improvement.
 When set, this setting cannot be reset during the same session, for
 obvious security reasons.
+
+@item LOCALE
+@cindex locale
+@cindex encoding, characters
+This item is used to set the default character encoding.
+The encoding may be specified either as an encoding name or alias
+(see @url{http://www.iana.org/assignments/character-sets}), or
+as a locale name.
+If given as a locale name, only the character encoding of the 
+locale is relevant.
+
+System files written by PSPP will use this encoding.
+System files read by PSPP, for which the encoding is unknown, will be
+interpreted using this encoding.
+
+The full list of valid encodings and locale names/alias are operating system
+dependent.
+The following are all examples of acceptable syntax on common GNU/Linux
+systems.
+@example
+
+SET LOCALE='iso-8859-1'.
+
+SET LOCALE='ru_RU.cp1251'.
+
+SET LOCALE='japanese'.
+
+@end example
+
+Contrary to the intuition, this command does not affect any aspect 
+of the system's locale.
 @end table
 
 @node SHOW
@@ -784,4 +820,3 @@ on the output device.
 Specify a title as a string in quotes.  The alternate syntax that did
 not require quotes is now obsolete.  If it is used then the title is
 converted to all uppercase.
-@setfilename ignored