sheet meta data: Move out of state data

[pspp] / doc / transformation.texi

diff --git a/doc/transformation.texi b/doc/transformation.texi
index 605c08cd94d7e4792f17780eb447bedcffff7396..5ea809e54f7e0ebd67bfeb343cd22000b29e759c 100644 (file)
--- a/doc/transformation.texi
+++ b/doc/transformation.texi
@@ -519,7 +519,7 @@ The source values are used to specify the values in the dataset which
 need to change, and the destination value specifies the new value
 to which they should be changed.
 Each @var{src_value} may take one of the following forms:
-@itemize @bullet
+@table @asis
 @item @var{number}
 If the source variables are numeric then @var{src_value} may be a literal
 number.
@@ -528,11 +528,9 @@ If the source variables are string variables then @var{src_value} may be a
 literal string (like all strings, enclosed in single or double quotes).
 @item @var{num1} THRU @var{num2}
 This form is valid only when the source variables are numeric.
-It specifies all values in the range [@var{num1}, @var{num2}].
-Normally you would ensure that @var{num2} is greater than or equal to
-@var{num1}.
-If @var{num1} however is greater than @var{num2}, then the range 
-[@var{num2},@var{num1}] will be used instead.
+It specifies all values in the range between @var{num1} and @var{num2},
+including both endpoints of the range.  By convention, @var{num1}
+should be less than @var{num2}.
 Open-ended ranges may be specified using @samp{LO} or @samp{LOWEST} 
 for @var{num1}
 or @samp{HI} or @samp{HIGHEST} for @var{num2}.
@@ -549,11 +547,11 @@ The @samp{ELSE} keyword may be used to match any values which are
 not matched by any other @var{src_value} appearing in the command.
 If this keyword appears, it should be used in the last mapping of the 
 command.
-@end itemize
+@end table
 
 After the source variables comes an @samp{=} and then the @var{dest_value}.
 The @var{dest_value} may take any of the following forms:
-@itemize @bullet
+@table @asis
 @item @var{number}
 A literal numeric value to which the source values should be changed.
 This implies the destination variable must be numeric.
@@ -569,7 +567,7 @@ The special keyword @samp{COPY} means that the source value should not be
 modified, but
 copied directly to the destination value.
 This is meaningful only if @samp{INTO @var{dest_vars}} is specified.
-@end itemize
+@end table
 
 Mappings are considered from left to right.
 Therefore, if a value is matched by a @var{src_value} from more than