Correct typo in BINOMIAL section of user manual.

[pspp-builds.git] / doc / statistics.texi

diff --git a/doc/statistics.texi b/doc/statistics.texi
index 8db018f7854dc17079aed77bfc4e9acf22ee9961..8fa93b1566a38fe304836d8d473fcc2dde7189b3 100644 (file)
--- a/doc/statistics.texi
+++ b/doc/statistics.texi
@@ -133,9 +133,6 @@ FREQUENCIES
         /BARCHART=@dots{}
         /HBAR=@dots{}
         /GROUPED=@dots{}
-
-(Integer mode.)
-        /VARIABLES=var_list (low,high)@dots{}
 @end display
 
 The @cmd{FREQUENCIES} procedure outputs frequency tables for specified
@@ -148,16 +145,7 @@ histograms and pie charts.  In the future, it will be able to produce
 bar charts and output percentiles for grouped data.
 
 The VARIABLES subcommand is the only required subcommand.  Specify the
-variables to be analyzed.  In most cases, this is all that is required.
-This is known as @dfn{general mode}.
-
-Occasionally, one may want to invoke a special mode called @dfn{integer
-mode}.  Normally, in general mode, PSPP will automatically determine
-what values occur in the data.  In integer mode, the user specifies the
-range of values that the data assumes.  To invoke this mode, specify a
-range of data values in parentheses, separated by a comma.  Data values
-inside the range are truncated to the nearest integer, then assigned to
-that value.  If values occur outside this range, they are discarded.
+variables to be analyzed.
 
 The FORMAT subcommand controls the output format.  It has several
 possible settings:  
@@ -558,7 +546,7 @@ values.
 If more than two distinct, non-missing values for a variable
 under test are encountered then an error occurs.
 
-If the test proportion is equal to 0.5, then a one tailed test is
+If the test proportion is equal to 0.5, then a two tailed test is
 reported.   For any other test proportion, a one tailed test is
 reported.   
 For one tailed tests, if the test proportion is less than
@@ -742,7 +730,7 @@ of variable preceding @code{WITH} against variable following
 ONEWAY
         [/VARIABLES = ] var_list BY var
         /MISSING=@{ANALYSIS,LISTWISE@} @{EXCLUDE,INCLUDE@}
-        /CONTRASTS= value1 [, value2] ... [,valueN]
+        /CONTRAST= value1 [, value2] ... [,valueN]
         /STATISTICS=@{DESCRIPTIVES,HOMOGENEITY@}
 
 @end display
@@ -768,7 +756,7 @@ Displays the Levene test of Homogeneity of Variance for the
 variables and their groups.
 @end itemize
 
-The @code{CONTRASTS} subcommand is used when you anticipate certain
+The @code{CONTRAST} subcommand is used when you anticipate certain
 differences between the groups.
 The subcommand must be followed by a list of numerals which are the
 coefficients of the groups to be tested.
@@ -776,7 +764,7 @@ The number of coefficients must correspond to the number of distinct
 groups (or values of the independent variable).
 If the total sum of the coefficients are not zero, then PSPP will
 display a warning, but will proceed with the analysis.
-The @code{CONTRASTS} subcommand may be given up to 10 times in order
+The @code{CONTRAST} subcommand may be given up to 10 times in order
 to specify different contrast tests.
 @setfilename ignored