recommend version 2.10.2 or later.
* libglade (http://www.jamesh.id.au/software/libglade/), version
- 2.0 or later.
+ 2.6 or later.
The following packages are optional.
Running `configure' takes awhile. While running, it prints some
messages telling which features it is checking for.
- When `configure' completes, it may print a list of packages that
- you must install before PSPP. If it does, you need to install
- those packages, then re-run this step. Some prerequisites may be
+ If `configure' completes successfully, it prints the message
+ "PSPP configured successfully." at the end of its run.
+ Otherwise, it may stop with a list of packages that you must
+ install before PSPP. If it does, you need to install those
+ packages, then re-run this step. Some prerequisites may be
omitted by passing a --without-<feature> flag to `configure' (see
"Optional Features", below). If you use one of these flags, then
the feature that it disables will not be available in your PSPP
installation.
`configure' may also print a list of packages that you should
- consider installing. If you install them, additional features
- will be available in your PSPP installation.
+ consider installing. If you install them, then re-run
+ `configure', additional features will be available in your PSPP
+ installation.
2. Type `make' to compile the package.