+/* DLAB=0 registers. */
+#define RBR_REG (IO_BASE + 0) /* Receiver Buffer Reg. (read-only). */
+#define THR_REG (IO_BASE + 0) /* Transmitter Holding Reg. (write-only). */
+#define IER_REG (IO_BASE + 1) /* Interrupt Enable Reg. (read-only). */
+#define FCR_REG (IO_BASE + 2) /* FIFO Control Reg. (write-only). */
+#define LCR_REG (IO_BASE + 3) /* Line Control Register. */
+#define MCR_REG (IO_BASE + 4) /* MODEM Control Register. */
+#define LSR_REG (IO_BASE + 5) /* Line Status Register (read-only). */
+
+/* DLAB=1 registers. */
+#define LS_REG (IO_BASE + 0) /* Divisor Latch (LSB). */
+#define MS_REG (IO_BASE + 1) /* Divisor Latch (MSB). */
+
+/* Interrupt Enable Register bits. */
+#define IER_XMIT 0x02 /* Interrupt when transmit finishes. */
+
+/* Line Control Register bits. */
+#define LCR_N81 0x03 /* No parity, 8 data bits, 1 stop bit. */
+#define LCR_DLAB 0x80 /* Divisor Latch Access Bit (DLAB). */
+
+/* MODEM Control Register. */
+#define MCR_OUT2 0x08 /* Output line 2. */
+
+/* Line Status Register. */
+#define LSR_THRE 0x20 /* THR Empty. */
+\f
+/* Transmission mode. */
+static enum { UNINIT, POLL, QUEUE } mode;
+
+/* Data to be transmitted. */
+static struct intq txq;
+
+static void set_serial (int bps);
+static void putc_poll (uint8_t);
+static void write_ier (void);
+static intr_handler_func serial_interrupt;
+
+/* Initializes the serial port device for polling mode.
+ Polling mode busy-waits for the serial port to become free
+ before writing to it. It's slow, but until interrupts have
+ been initialized it's all we can do. */