X-Git-Url: https://pintos-os.org/cgi-bin/gitweb.cgi?a=blobdiff_plain;f=vswitchd%2Fvswitch.xml;h=b74c55c8c7bea197cca76b13d36d82980befb687;hb=ebb57021a9827b59997a00defc32bf761bc16148;hp=470f38971e733a905162e1532bf8d23dbfe3b551;hpb=c45ab5e9b76adc4097a3243bfc07502e658ccd5c;p=openvswitch diff --git a/vswitchd/vswitch.xml b/vswitchd/vswitch.xml index 470f3897..b74c55c8 100644 --- a/vswitchd/vswitch.xml +++ b/vswitchd/vswitch.xml @@ -637,6 +637,13 @@ LACP negotiations, link status decisions are made by the system with the numerically lower priority. Must be a number between 1 and 65535. +
lacp-time
fast
and
+ slow
. By default slow
is used. When
+ configured to be fast
more frequent LACP heartbeats
+ will be requested causing connectivity problems to be detected more
+ quickly.- The observed state of the physical network link; - i.e. whether a carrier is detected by the interface. + The observed state of the physical network link. This is ordinarily + the link's carrier status. If the interface's is + a bond configured for miimon monitoring, it is instead the network + link's miimon status.
discover
Enables controller discovery.
-In controller discovery mode, Open vSwitch broadcasts a DHCP
- request with vendor class identifier OpenFlow
across
- all of the bridge's network devices. It will accept any valid
- DHCP reply that has the same vendor class identifier and includes
- a vendor-specific option with code 1 whose contents are a string
- specifying the location of the controller in the same format as
- .
The DHCP reply may also, optionally, include a vendor-specific
- option with code 2 whose contents are a string specifying the URI
- to the base of the OpenFlow PKI
- (e.g. http://192.168.0.1/openflow/pki
). This URI is
- used only for bootstrapping the OpenFlow PKI at initial switch
- setup; ovs-vswitchd
does not use it at all.
The following connection methods are currently supported for service @@ -1768,10 +1744,7 @@ -
If not specified, the default is implementation-specific. If
- is discover
, the connection mode
- is always treated as in-band
regardless of the actual
- setting.
If not specified, the default is implementation-specific.
These values are considered only when
- is discover
.
^
. If not specified, the default
- is implementation-specific.
- /etc/resolv.conf
when the
- controller is discovered. If not specified, the default
- is implementation-specific. Open vSwitch will only modify
- /etc/resolv.conf
if the DHCP response that it receives
- specifies one or more DNS servers.
- These values are considered only in in-band control mode (see
- ) and only when
- is not discover
. (For controller discovery, the network
- configuration obtained via DHCP is used instead.)
When multiple controllers are configured on a single bridge, there should be only one set of unique values in these columns. If different