X-Git-Url: https://pintos-os.org/cgi-bin/gitweb.cgi?a=blobdiff_plain;f=vswitchd%2Fvswitch.xml;h=13d24b69f47442f50e08640ffbc9435003fa47d9;hb=8a77bb2ec8d25a61955bbb041cf1e45e8966da76;hp=0cd9b30cb7c60be65db3bef9ec07377c8fced151;hpb=749ae9504293dbb695dd67402acbd47acbcbeb83;p=openvswitch
diff --git a/vswitchd/vswitch.xml b/vswitchd/vswitch.xml
index 0cd9b30c..13d24b69 100644
--- a/vswitchd/vswitch.xml
+++ b/vswitchd/vswitch.xml
@@ -556,6 +556,46 @@
and if Open vSwitch node does not run STP, then this option
should be enabled. Default is disabled, set to
true
to enable.
+
+ The following destination MAC addresss will not be forwarded when this
+ option is enabled.
+
01:80:c2:00:00:00
01:80:c2:00:00:01
01:80:c2:00:00:0x
00:e0:2b:00:00:00
00:e0:2b:00:00:04
and 00:e0:2b:00:00:06
+ 01:00:0c:cc:cc:cc
01:00:0c:cc:cc:cd
01:00:0c:cd:cd:cd
01:00:0c:00:00:00
01:00:0c:cc:cc:cx
Indicates the health of the interface as a percentage of CCM frames @@ -2084,7 +2119,7 @@
The eviction process only considers flows that have an idle timeout or a hard timeout. That is, eviction never deletes permanent flows. - (Permanent flows do count against . + (Permanent flows do count against .)
@@ -2315,36 +2350,12 @@ sent out an implicit VLAN port, the frame will not be tagged. This type of mirroring is sometimes called RSPAN.
- The following destination MAC addresses will not be mirrored to a - VLAN to avoid confusing switches that interpret the protocols that - they represent: + See the documentation for + in the + table for a list of destination MAC + addresses which will not be mirrored to a VLAN to avoid confusing + switches that interpret the protocols that they represent.
-01:80:c2:00:00:00
01:80:c2:00:00:01
01:80:c2:00:00:0x
01:00:0c:cc:cc:cc
01:00:0c:cc:cc:cd
01:00:0c:cd:cd:cd
01:00:0c:00:00:00
Please note: Mirroring to a VLAN can disrupt a network that contains unmanaged switches. Consider an unmanaged physical switch with two ports: port 1, connected to an end host, and port 2, @@ -2735,10 +2746,9 @@ Service (QoS) on IP networks. The DSCP value specified here is used when establishing the connection - between the controller and the Open vSwitch. The connection must be - reset for the new DSCP values to take effect. If no value is - specified, a default value of 48 is chosen. Valid DSCP values must be - in the range 0 to 63. + between the controller and the Open vSwitch. If no value is specified, + a default value of 48 is chosen. Valid DSCP values must be in the + range 0 to 63.