<column name="system_version">
<p>
The version of the system identified by <ref column="system_type"/>,
- e.g. <code>5.5.0-24648p</code> on XenServer 5.5.0 build 24648.
+ e.g. <code>5.6.100-39265p</code> on XenServer 5.6.100 build 39265.
</p>
<p>
System integrators are responsible for choosing and setting an
<group title="Bonding Configuration">
<p>A port that has more than one interface is a ``bonded port.'' Bonding
- allows for load balancing and fail-over. Open vSwitch supports
- ``source load balancing'' (SLB) and "active backup" bonding. SLB
- bonding assigns flows to slaves based on source MAC address and output
- VLAN, with periodic rebalancing as traffic patterns change. Active
- backup bonding assigns all flows to one slave, failing over to a backup
- slave when the active slave is disabled. Neither form of bonding
- require 802.3ad or other special support from the upstream switch to
- which the slave devices are connected.</p>
+ allows for load balancing and fail-over. Some kinds of bonding will
+ work with any kind of upstream switch:</p>
+
+ <dl>
+ <dt><code>balance-slb</code></dt>
+ <dd>
+ Balances flows among slaves based on source MAC address and output
+ VLAN, with periodic rebalancing as traffic patterns change.
+ </dd>
+
+ <dt><code>active-backup</code></dt>
+ <dd>
+ Assigns all flows to one slave, failing over to a backup slave when
+ the active slave is disabled.
+ </dd>
+ </dl>
+
+ <p>
+ The following mode requires the upstream switch to support 802.3ad with
+ successful LACP negotiation. If LACP negotiation fails then
+ <code>balance-slb</code> mode is used as a fallback:
+ </p>
+
+ <dl>
+ <dt><code>balance-tcp</code></dt>
+ <dd>
+ Balances flows among slaves based on L2, L3, and L4 protocol
+ information such as destination MAC address, IP address, and TCP
+ port.
+ </dd>
+ </dl>
<p>These columns apply only to bonded ports. Their values are
otherwise ignored.</p>
<column name="bond_mode">
- <p>The type of bonding used for a bonded port. Currently supported
- values are <code>balance-slb</code> and <code>active-backup</code>.
- Defaults to SLB if unset.</p>
+ <p>The type of bonding used for a bonded port. Defaults to
+ <code>balance-slb</code> if unset.
+ </p>
</column>
<column name="bond_updelay">
and many kinds of virtual interfaces can be configured with
higher MTUs.
</p>
+ <p>
+ This column will be empty for an interface that does not
+ have an MTU as, for example, some kinds of tunnels do not.
+ </p>
</column>
<column name="status">