</p>
</column>
+ <column name="cfm_fault_status" key="recv">
+ Indicates a CFM fault was triggered due to a lack of CCMs received on
+ the <ref table="Interface"/>.
+ </column>
+
+ <column name="cfm_fault_status" key="rdi">
+ Indicates a CFM fault was triggered due to the reception of a CCM with
+ the RDI bit flagged. Endpoints set the RDI bit in their CCMs when they
+ are not receiving CCMs themselves. This typically indicates a
+ unidirectional connectivity failure.
+ </column>
+
+ <column name="cfm_fault_status" key="maid">
+ Indicates a CFM fault was triggered due to the reception of a CCM with
+ a MAID other than the one Open vSwitch uses. CFM broadcasts are tagged
+ with an identification number in addition to the MPID called the MAID.
+ Open vSwitch only supports receiving CCM broadcasts tagged with the
+ MAID it uses internally.
+ </column>
+
+ <column name="cfm_fault_status" key="loopback">
+ Indicates a CFM fault was triggered due to the reception of a CCM
+ advertising the same MPID configured in the <ref column="cfm_mpid"/>
+ column of this <ref table="Interface"/>. This may indicate a loop in
+ the network.
+ </column>
+
+ <column name="cfm_fault_status" key="overflow">
+ Indicates a CFM fault was triggered because the CFM module received
+ CCMs from more remote endpoints than it can keep track of.
+ </column>
+
+ <column name="cfm_fault_status" key="override">
+ Indicates a CFM fault was manually triggered by an administrator using
+ an <code>ovs-appctl</code> command.
+ </column>
+
<column name="cfm_remote_mpids">
When CFM is properly configured, Open vSwitch will occasionally
receive CCM broadcasts. These broadcasts contain the MPID of the