<dt><code>01:80:c2:00:00:0<var>x</var></code></dt>
<dd>Other reserved protocols.</dd>
- <dt><code>00:00:5e:00:01:<var>x</var><var>x</var></code></dt>
- <dd> VRRP IPv4 virtual router MAC address. </dd>
+ <dt><code>00:e0:2b:00:00:00</code></dt>
+ <dd>Extreme Discovery Protocol (EDP).</dd>
- <dt><code>00:00:5e:00:02:<var>x</var><var>x</var></code></dt>
- <dd> VRRP IPv6 virtual router MAC address. </dd>
-
- <dt><code>00:00:0c:07:ac:<var>x</var><var>x</var></code></dt>
- <dd> HSRP Version 1. </dd>
-
- <dt><code>00:00:0c:9f:f<var>x</var>:<var>x</var><var>x</var></code>
- </dt>
- <dd> HSRP Version 2. </dd>
-
- <dt><code>00:07:b4:<var>x</var><var>x</var>:<var>x</var><var>x</var>:<var>x</var><var>x</var></code></dt>
- <dd> GLBP. </dd>
+ <dt>
+ <code>00:e0:2b:00:00:04</code> and <code>00:e0:2b:00:00:06</code>
+ </dt>
+ <dd>Ethernet Automatic Protection Switching (EAPS).</dd>
<dt><code>01:00:0c:cc:cc:cc</code></dt>
<dd>
<dt><code>01:00:0c:00:00:00</code></dt>
<dd>Cisco Inter Switch Link.</dd>
+
+ <dt><code>01:00:0c:cc:cc:c<var>x</var></code></dt>
+ <dd>Cisco CFM.</dd>
</dl>
</column>
<group title="Bonding Configuration">
<p>A port that has more than one interface is a ``bonded port.'' Bonding
- allows for load balancing and fail-over. Some kinds of bonding will
- work with any kind of upstream switch:</p>
+ allows for load balancing and fail-over.</p>
+
+ <p>
+ The following types of bonding will work with any kind of upstream
+ switch. On the upstream switch, do not configure the interfaces as a
+ bond:
+ </p>
<dl>
<dt><code>balance-slb</code></dt>
<dt><code>active-backup</code></dt>
<dd>
Assigns all flows to one slave, failing over to a backup slave when
- the active slave is disabled.
+ the active slave is disabled. This is the only bonding mode in which
+ interfaces may be plugged into different upstream switches.
</dd>
</dl>
frame having an invalid interval.
</column>
- <column name="cfm_fault_status" key="sequence">
- Indicates a CFM fault was triggered because the CFM module received
- a CCM frame with a sequence number that it was not expecting.
+ <column name="cfm_remote_opstate">
+ <p>When in extended mode, indicates the operational state of the
+ remote endpoint as either <code>up</code> or <code>down</code>. See
+ <ref column="other_config" key="cfm_opstate"/>.
+ </p>
</column>
<column name="cfm_health">
<p>
The eviction process only considers flows that have an idle timeout or
a hard timeout. That is, eviction never deletes permanent flows.
- (Permanent flows do count against <ref column="flow_limit"/>.
+ (Permanent flows do count against <ref column="flow_limit"/>.)
</p>
<p>