cfm: Remove packet definition from CFM header file.

[openvswitch] / utilities / ovs-vsctl.8.in

diff --git a/utilities/ovs-vsctl.8.in b/utilities/ovs-vsctl.8.in
index 0b3e164efec4b0a7572a49f220ab492ff9075cc1..97944dfb6fc65077be462e6ccf183fcee3efc63e 100644 (file)
--- a/utilities/ovs-vsctl.8.in
+++ b/utilities/ovs-vsctl.8.in
@@ -483,11 +483,6 @@ identified by port name.
 .IP "\fBQueue\fR"
 Configuration for one queue within a \fBQoS\fR configuration.  Records
 may only be identified by UUID.
-.IP "\fBMonitor\fR"
-Connectivity Monitoring attached to an \fBInterface\fR.  Records may be
-identified by \fBInterface\fR name.
-.IP "\fBMaintenance_Point\fR"
-Maintenance Point managed by a \fBMonitor\fR.
 .IP "\fBMirror\fR"
 A port mirroring configuration attached to a bridge.  Records may be
 identified by mirror name.
@@ -596,6 +591,11 @@ For a map column, without \fB\-\-if\-exists\fR it is an error if
 If \fB@\fIname\fR is specified, then the UUID for \fIrecord\fR may be
 referred to by that name later in the same \fBovs\-vsctl\fR
 invocation in contexts where a UUID is expected.
+.IP
+Both \fB\-\-id\fR and the \fIcolumn\fR arguments are optional, but
+usually at least one or the other should be specified.  If both are
+omitted, then \fBget\fR has no effect except to verify that
+\fIrecord\fR exists in \fItable\fR.
 .
 .IP "\fBset \fItable record column\fR[\fB:\fIkey\fR]\fB=\fIvalue\fR..."
 Sets the value of each specified \fIcolumn\fR in the given
@@ -778,19 +778,13 @@ their UUIDs, then "\fBovs\-vsctl destroy Queue \fIuuid1\fR
 \fIuuid2\fR" to destroy each of them.)
 .SS "Connectivity Monitoring"
 .PP
-Create a Monitor which manages a couple of remote Maintenance Points on eth0.
-.IP
-.B "ovs\-vsctl \-\- set Interface eth0 Monitor=@newmon \(rs"
-.IP
-.B "\-\- \-\-id=@newmon create Monitor mpid=1 remote_mps=@mp2,@mp3 \(rs"
-.IP
-.B "\-\- \-\-id=@mp2 create Maintenance_Point mpid=2 \(rs"
+Monitor connectivity to a remote maintenance point on eth0.
 .IP
-.B "\-\- \-\-id=@mp3 create Maintenance_Point mpid=3"
+.B "ovs\-vsctl set Interface eth0 cfm_mpid=1 cfm_remote_mpid=2"
 .PP
-Deconfigure the Monitor record from above:
+Deconfigure connectivity monitoring from above:
 .IP
-.B "ovs\-vsctl clear Interface eth0 Monitor"
+.B "ovs\-vsctl clear Interface eth0 cfm_mpid cfm_remote_mpid"
 .SS "NetFlow"
 .PP
 Configure bridge \fBbr0\fR to send NetFlow records to UDP port 5566 on