-To build this project from the sources direct from the cvs archive,
-you must install the prerequisites listed in README, plus the
-following:
-
- * Autoconf 2.60 (or later).
-
- * Automake 1.10 (or later).
-
- * Gettext 0.17 (or later).
-
- * GNU M4 1.4.9 (or later).
-
- * pkg-config 0.21 (or later).
-
- * gperf 3.0.1 (or later).
-
- * Gnulib, from Git at <git://git.savannah.gnu.org/gnulib.git>.
- If you do not have Git installed, up-to-date snapshots are
- at <http://git.savannah.gnu.org/gitweb/?p=gnulib.git>.
- Note that Gnulib does not require any form of installation:
- simply checking it out into a directory is sufficient. We
- recommend checking out gnulib into a directory named `gnulib'
- at the same level as PSPP.
-
- * libtool 1.5.22 (or later).
-
- * Texinfo 4.7 or later, to build the documentation.
-
-Once you have these installed, execute
- make -f Smake
-If you checked Gnulib out in a directory named `gnulib' at the same
-level as PSPP, then this is sufficient. Otherwise, provide the
-location of GNULIB on the `make' command line:
- make -f Smake GNULIB=/gnulib/base/directory/name
-
-After executing Smake, you may configure the source tree in the usual
-way with ./configure, e.g.
- ./configure
-For a list of options:
- ./configure --help
-
-To test:
- make check
-
-For a very thorough test:
- make distcheck